|
| |
|
|
| [ 文章来源： | 文章作者：
| 发布时间：2006-09-23|
字体：
[大
中
小]
| |
|
NorthernsStuff you need:
10X running buffer:
50 mM NaOAc
0.2M MOPS pH 7.0
10 mM EDTA
filter, store in dark at RT, pH to 7.0
Formaldehyde gel:
0.9% agarose in 1X running buffer, and 1ml formaldehyde per 20 ml gel. (For 200 ml gel, dissolve 1.8 g agarose in 170 ml water, let cool in 65 deg C water bath, add 10 ml formaldehyde (37% stock), and 20 ml 10X MOPS running buffer).
1.5X Loading buffer:
750 祃 formamide
75 祃 formaldehyde (37%)
150 祃 10X running buffer
15 祃 EtBr (5 mg/ml)
10 祃 ddH20
Best results if made fresh each time
Loading Dye:
Bromophenol blue in 35% glycerol and 1X running buffer
20X SSC:
3M NaCl
0.3M Na Citrate
pH 7.0
1. Pour gel in hood.
2. Mix RNA (10礸) with 1.5X loading buffer (e.g. 10 祃 RNA + 20祃 LB).
3. Incubate 5 min at 65 deg C. Cool on ice.
4. Add 2 祃 loading dye.
5. Pre-run gel at 5 V/cm for 5 minutes. Load samples and run. Mix buffers after 3 hours.
6. Wash gel 2X in water for 15 min, then 1X in 10X SSC for 15 minutes. Photograph gel under UV.
7. Cut nylon membrane (MSI 0.45 礽cron #N04HY00010) and several pieces of blotting (e.g. Schleicher and Schuell GB002) paper to the same size as the gel. Wet the nylon with dH20, then soak in 5x SSC.
8. Assemble sandwich:
a. Large sheet of plastic wrap
b. Two pieces blot paper (precut to same size as gel) soaked in 20x SSC
c. Gel (wells-side down)
d. Presoaked nylon
e. One piece blot paper soaked in 5x SSC
f. 10-15 pieces of dry blot paper
h. Wrap whole sandwich in the plastic wrap
i. Place glass plate and weight on top and let transfer >3 hr.
9. Crosslink after blotting.
10. Can probe either with non-radioactive probe or with radioactive probe.
上一篇：Pre-hyb/hyb for Radioactive Probes 下一篇：Northern Blot
|
|
|
Pre-hyb/hyb for&nbs