|
| |
|
|
| Digoxigenin-UTP RNA labeling
|
| [ 文章来源： | 文章作者：
| 发布时间：2006-09-23|
字体：
[大
中
小]
| |
|
1. Add the following to a sterile microfuge tube on ice:
-1 ug linearized plasmid DNA.
-2 ul Dig RNA Labeling Mix, 10X concentrate
-2 ul 10X transcription buffer
-1-2 ul RNase inhibitor (DNase free)
-add DEPC treated H2O up to 18 ul
-2 ul RNA polymerase as appropriate
2. Mix then spin down briefly.
3. Incubate at 37'C for 2-3 hours.
4. Add 2 ul DNase I, RNase free to remove DNA template.
5. Incubate at 37'C for 15 minutes.
10X NTP Labeling Mix: 10mM ATP, CTP, GTP, 6.5mM UTP, 3.5mM DIG in Tris-HCl,
pH 7.5.
10X Transcription Buffer:
400mM Tris-HCl, pH 8.0; 60mM MgCl2, 100mM dithioerythritol, 20mM spermidine, 100mM NaCl, 1U/ml RNase Inhibitor.
Ethanol Precipitation of RNA transcripts:
Note: Use DEPC treated H2O to make reagents.
1. Add 2.5 ul 3M Sodium Acetate and 75 ul 100% ethanol (-20'C) to
the above reaction.
2. Mix well then store at -70'C for at least 30 minutes.
3. Centrifuge at 12,000 X g at 4'C for 15 minutes.
4. Wash the pellet carefully with 70% ETOH DEPC treated and(-20'C).
5. Repeat centrifugation. Aspirate supernatant. Dry under vacuum.
6. Dissolve in 10 ul DEPC treated H2O for acrylamide purification or
in 100 ul of 0.5% SDS for direct use in situ.
Note: Riboprobes are best stored for long periods of time in ETOH at -70'C.
Determination of Labeling efficiency:
1. Make serial dilutions the transcription reaction in the range of
100 pg/ul to 0.1 pg/ul in sterile, RNase free water and spot on BM positively
charged membrane.
2. UV cross link.
3. See "Detection of DIG labeled nucleic acids".
上一篇：E.coli Total RNA Labeling Protocol for Spotted Microarray 下一篇：蛋白质提取与纯化技术
|
|
|
E.coli Total RNA Labelin